Mama devlopers

Search This Blog

ACN

Get link
Facebook
X
Pinterest
Email
Other Apps

ACN

Advance Computer Noetworks

Get link
Facebook
X
Pinterest
Email
Other Apps

Search This Blog

Total Pageviews

Devloper

Contact form

Name

Email *

Message *

The output of four registers R0, R1, R2 and R3 are connected through 4 to 1 line multiplexer to the inputs of a fifth register, R5. Each register is eight bit long. The required transfer are dictated by four timing variables T0 through T3 as follows:

Q.) The output of four registers R0, R1, R2 and R3 are connected through 4 to 1 line multiplexer to the inputs of a fifth register, R5. Each register is eight bit long. The required transfer are dictated by four timing variables T0 through T3 as follows: T0: R5 ß R0 T1: R5 ß R1 T2: R5 ß R2 T3: R5 ß R3 The timing variables are mutually exclusive, which means that only one variable is equal to 1 at any given time, while the other three are equal to 0. Draw a block diagram showing the hardware implementation of the register transfers. Include the connections necessary from the four timing variables to the selection inputs of the multiplexers and to the load input of register R5. Ans.) T0: R5 <--- R0 T1: R5 <--- R1 Ø T2: R5 <--- R2 Ø T3: R5 <--- R3 Ø The timing variable are mutually exclusive, which means that only one variable is equal to 1 at any given time, while the other three are equal 0. Draw a block diagram showi...

Show the block diagram of hardware that implements the following register transfer statement: yT2 : R1  R1, R1 R2

Q.) Show the block diagram of the hardware (Similar to fig. 4.2a) that implements the following register transfer statement: yT2: R<-- R1, R1 <-- R2 Ans.) Ø Here we have used AND gate because in the equation we can see that both the input is in multiplication so we have to use the gate accordingly Ø The output from the AND gate is transferred to the register R1 & R2 the data is transferred from R1 to R2 and from R2 to R1 Ø Both the register are connected to clock

Represent the following conditional control statement by two register transfer statements with control functions. If (P=1) then (R1ßR2) else if (Q = 1) then (R1 R3)

Represent the following conditional control statement by two register transfer statements with control functions. If (P=1) then (R1 ß R2) else if (Q = 1) then (R1 ß R3) ANS Here for P=1 then data is transferred from R2 to R1 else if O=1 then it is transfer from R3 to R1 P: R1 ← R2 P'Q: R1 ← R3

Enginnering Portal